In HEALTH=1 builds health_phase(HEALTH_LLDP) used id 7 while ph_max[] and
ph_slow[] had HEALTH_PHASES = 6 entries. The LLDP checkpoint therefore
wrote one byte past ph_max (into the high byte of ph_slow[0]) and, when
the phase took two ticks or more, incremented two bytes past ph_slow
(dhcp_state.state and transaction_id on KP_9000_6XHML_X2).
Rename it HEALTH_PH_LLDP = 6, derive HEALTH_PHASES from it so the arrays
always cover the last phase, print an lldp line in "health" and document
it.
Fixes#658
Chrome on macOS labels .bin files application/macbinary. Searching for application/octet-stream mistakes the image bytes for more part headers and aborts when the preamble buffer fills.
Find the multipart header terminator instead, after the HTTP separator retained by handle_post. Keep authentication, CRC checks and staging limits unchanged. Cover MacBinary, an omitted part Content-Type, and a split header terminator with exact staged-byte checks.
the bits we need
But we need both main and branch checked out and the action can
do it for us
Pulling the bank occupancy from the map produced by sdcc rather
than the output of the build as it appears the output number is
only the maximum size of the banks
BANK0 isn't output, but what I'm guessing are the consituents for it are
With UIP_CONF_MAX_CONNECTIONS set to one, a verified upload can leave
reset intent set when its response is never acknowledged. A subsequent
TCP connection reuses that slot, and ACKing its plain GET response can
otherwise trigger reset_chip(). This is sequential slot reuse, not
concurrent HTTP connections.
Store reset intent in the connection appstate and initialize both tstate
and fw_reset_pending on every uip_connected() event, regardless of stale
appstate contents. Reset only after the verified upload response is fully
acknowledged.
Exercise the real HTTP callback for all stale tstate bytes, sequential
slot reuse and a later GET, partial/final ACKs, abort, timeout and CRC
failure. Keep the regression tests in the existing tab-indented style.
Address review by documenting regget 4 and RTL8373 N/non-N ID values under Step 4 of adding-a-device.md, without referring to a particular board or set of units. Keep the verified Horaco CPU and flash capacity in its device table and retain the unverified-chip caveat.
Read register 0x0004 on all three tested HC-SWTGW218AS units. Each returned 0x83730000, identifying RTL8373 rather than RTL8373N. Firmware reports 2 MB flash on all three.
Fill in the verified device-table fields and document the non-N/N register distinction. Leave PHY and flash-chip models explicitly unverified.
Rob Emery
feelfree69
Andre Brait
HL Yi
Kamikaze94
logicog
dobodu
bloq
René van Dorst
avicarmeli
João Silva
d00f