Three more bench scenarios around the closing boundary. Every value
of the last image byte, uploaded whole and split right after the
payload, must end the part. A run of CR before the boundary of even
length passed before the fix and an odd one did not, so both are
checked. An image made of CR only, longer than a flash page, and one
made of repeated "\r\n-" exercise the broken matches back to back:
each one appends to the page buffer without a byte written, and the
page flush after both paths has to keep up.
stream_upload() matches the closing multipart boundary byte by byte.
When a byte breaks a partial match, the matched prefix goes to flash as
data, and so does the breaking byte, without being compared against the
start of the boundary.
The boundary starts with "\r\n--", so an image whose last byte is '\r'
never completes: that '\r' starts a match, the '\r' of the boundary
breaks it and is written as data, and the rest of the boundary no
longer matches. The browser waits for a reply that never comes.
Flush the matched prefix and look at the breaking byte again from the
start of the boundary. A boundary may not contain CR, so no longer
suffix of the matched prefix can start a new match.
The masks were 0, so 0x3e2 was ORed into the reset value 0xbff and both
SerDes stayed off on boards without 10G ports (n_10g == 0), e.g. the
HC-SWTG124AS. With SDS 0 off RTL837X_REG_SEC_COUNTER does not hold a
written value: it reads 0, so NTP never retried after a failed first
attempt at boot and froze the clock after a sync.
Tested with regset on an HC-SWTG124AS: the register keeps a write with
SDS 0 in SGMII or 10GR, not with SDS 0 off (also not with only SDS 1
on).
Firefox filled a saved login into the System tab's password fields and
its user name into the NTP poll interval, the input before them. That
input event marked the Time card as edited, so ntpLoad() left NTP off,
the server empty and the time zone at UTC-12:00.
In HEALTH=1 builds health_phase(HEALTH_LLDP) used id 7 while ph_max[] and
ph_slow[] had HEALTH_PHASES = 6 entries. The LLDP checkpoint therefore
wrote one byte past ph_max (into the high byte of ph_slow[0]) and, when
the phase took two ticks or more, incremented two bytes past ph_slow
(dhcp_state.state and transaction_id on KP_9000_6XHML_X2).
Rename it HEALTH_PH_LLDP = 6, derive HEALTH_PHASES from it so the arrays
always cover the last phase, print an lldp line in "health" and document
it.
Fixes#658
Chrome on macOS labels .bin files application/macbinary. Searching for application/octet-stream mistakes the image bytes for more part headers and aborts when the preamble buffer fills.
Find the multipart header terminator instead, after the HTTP separator retained by handle_post. Keep authentication, CRC checks and staging limits unchanged. Cover MacBinary, an omitted part Content-Type, and a split header terminator with exact staged-byte checks.
the bits we need
But we need both main and branch checked out and the action can
do it for us
Pulling the bank occupancy from the map produced by sdcc rather
than the output of the build as it appears the output number is
only the maximum size of the banks
BANK0 isn't output, but what I'm guessing are the consituents for it are
d00f
feelfree69
robs
Luca S.
HL Yi
René van Dorst
Rob Emery
Andre Brait
Kamikaze94
logicog
bloq
avicarmeli
João Silva