mirror of
https://github.com/logicog/RTLPlayground.git
synced 2026-08-30 14:52:51 +08:00
62 lines
1.7 KiB
Markdown
62 lines
1.7 KiB
Markdown
# Hisource Hi-KO4022WS
|
||
|
||
Following is documentation for unmanaged switch marked as `Hi-KO4022WS`.
|
||
|
||
Original software is running UART on 9600 baud rate.
|
||
|
||
Using SPI clamp in-board is the only method for initial installation.
|
||
|
||
The board has two flash chips `BY25Q16BS` with 16M-bit size. The front switch, switches between the two flash chips.
|
||
These can be programed independently by using said switch - so it is e.g. possible to run the original and new firmware in parallel.
|
||
|
||
### Label specifications
|
||
|
||
- **Name**: 2.5G Ethernet Switch
|
||
- **Model**: Hi-K0402WS
|
||
- **Ports**:
|
||
- 4 × RJ45: 10/100/1000/2500 Mbps
|
||
- 2 × SFP: 1000 / 2500 / 10000 Mbps
|
||
|
||
### What works (expected from label + similar devices)
|
||
|
||
- All four 2.5GBASE-T RJ45 ports at 10/100/1000/2500 Mbps
|
||
- Both SFP ports supporting 1G, 2.5G and 10G modules
|
||
- LEDs
|
||
|
||
### PCB overview
|
||
|
||
**Board markings**
|
||
- Top silkscreen: PCB-KO4022W-V3.0 / DIP-KO4022WS-V3.0
|
||
|
||
Top side
|
||
|
||
<img src="photos/K0402W-V3.0-unmanaged\PCB-top.jpg" width="300" />
|
||
|
||
Bottom
|
||
|
||
<img src="photos/K0402W-V3.0-unmanaged\PCB-bottom.jpg" width="300" />
|
||
|
||
### T2, serial console
|
||
|
||
| `J2` pin | Signal |
|
||
| -------- | ----------- |
|
||
| 1 | 3V3 |
|
||
| 2 | RX (Input) |
|
||
| 3 | TX (Output) |
|
||
| 4 | GND |
|
||
|
||
|
||
## Power supply
|
||
|
||
Input power is delivered via barell plug, `12V 1A` adapter was provided.
|
||
Board has two supply rails. `0.95` and `3.3` volt.
|
||
|
||
### `0.95` Core Voltage
|
||
|
||
Voltage is made by a `Techcode TD1720` .
|
||
|
||
### `3.3` Voltage
|
||
|
||
Voltage is created by chip marked as `Techcode TD1720`.
|
||
There seems to have been a miscalculation when choosing the inductor and the device is ~25% more efficient with an 5V power supply.
|