Ports click a port for details
System
Traffic packets/s, live
| Port | Link | TX pps | RX pps | TX bad | RX bad |
|---|
Port configuration
| Port | Name | Link | Devices learned | Speed | Enabled | MTU |
|---|
SFP speed is set per slot and is not saved in the startup config.
Spanning tree RSTP, 802.1w
-
Lower priority wins the root election (default 8 = 32768). Settings apply immediately; use Save to flash to keep them.
Port configuration
| Port | Enabled | Edge | Path cost | Priority | Guard | BPDU filter | Point-to-point |
|---|
Edge ports forward immediately and cause no topology change; Auto treats a port as edge after 3 s without BPDUs, and any received BPDU revokes it. Path cost 0 = automatic.
Port status
| Port | Role | State | Designated bridge | Designated port | Designated cost | Oper. edge | Oper. P2P |
|---|
Port statistics totals since boot
| Port | Name | Link | TX good | TX bad | RX good | RX bad |
|---|
VLANs Management VLAN: -
| VID | Name | Members | Tagged | Untagged | PVID on |
|---|
VLAN editor
U = untagged member, T = tagged member, - = not a member. PVID assigns this VLAN to untagged ingress traffic.
Ingress filtering write-only: the state is not readable from the switch
MAC address table
| Port | MAC | VLAN | Type |
|---|
Port mirroring
Both = mirror RX and TX of the port to the monitor port.
Port isolation
A frame entering a port may only leave through the ports ticked in its row.
The cell of the port itself is always allowed.
A LAG needs at least one member to be saved in the startup config; applying an empty group clears it.
Energy Efficient Ethernet
| Port | Advertised | Link partner | Active | Enable |
|---|
Advertised and link-partner flags per speed: 100M, 1G, 2.5G. SFP ports do not support EEE.
Bandwidth limits Mbit/s, 0.016-10000
| Port | Ingress limit | Mbit/s | When exceeded | Egress limit | Mbit/s |
|---|
Storm control per port and traffic type, empty = off
| Port | Broadcast | Multicast | Unknown unicast | Unknown multicast |
|---|
Frames of a type above its limit are dropped where they enter the switch.
Network
Services
Service state reflects the startup config; runtime state is not readable.
Admin password
Takes effect immediately; save to flash to keep it after reboot.
Console
Display
Stored in this browser only.
Startup configuration , replayed on every boot
Maintenance
Firmware update
Upload an RTLPlayground image (512 KiB .bin). The image is staged to flash and CRC-checked; on success the switch reboots itself, re-verifies the image and applies it. The startup configuration is preserved.