It seems very likely that other versions are not compatible, so make it
clear by including it in the machine type and name. Also update the
documentation.
This board appears for example in the Davuaz Da-K6501W switch, and is
designed similarly to Hi-K0402WS.
However, it only has one SFP port and another 2.5G copper port using
RTL8221B 2.5G PHY instead. Also, some components on the board, like
additional LEDs, mode switch, and second flash chip are not populated.
Like earlier revisions of the K0402W(S) board, there is no UART, so
debugging is limited.
As this is an unmanaged switch, installation needs a flash programmer.
Looks like the SFP numbers are reversed, since GPIOs were mapped
to SFP numbers, the need to be reversed too. This fixes swapped
display of SFP stats on the webpage.
Added support for all leds on the device.
Stock port sets are slightly differently configured, where additional
LED0 on SET_0 and LED1&LED2 where configured for link/collisions/duplex.
This has not been reproduced as those lines are probably not connected
anywhere.
The SWTG018AS-A V2.0 is an 8x2.5GBit/s port + 1 SFP+ port unmanged device
It is sold in an unbranded casing e.g. by Ampcom.
Hardware:
SoC: RTL8373N
Additional PHY: RTL8224
Flash: Puya P25D40SH (4MBit, slimmer, not standard SOP-8 package!)
LEDs: 1 Green + 1 Orange per Ethernet port (green designates 2.5GBit)
1 Green LED for the SFP+ port
The photos already show a modified PCB: Unpopulated resistors R52 and R53
have been bridged in order to enable the serial console. The smaller flash
memory chip at U2 has been replaced with a Windbond 128MBit standard-sized
SOIC-8 chip in order to easily use SOIC clamps to flash the device. Also
the serial header has been populated.
Mark Captur
logicog
Brenda Streiff
bennydiamond
Jan Hoffmann
diijkstra
feelfree69
chriz
feelfree69
TylerDurden-23
René van Dorst
logicog