We use the SoC's UUID to generate a fixed MAC for a particular
switch device. The MAC generated uses a Realtek prefix and then
is followed by 3 bytes genertaed from the first 3 bytes of the
UUID xored with the last byte in order to prevent being able
to deduce the UUID from the public MAC.
RTL has up to 3 SCL pins and up to 4 SDA pins. Lets allow configuring
I2C with individual BUS numbers instead of 0/1 I2C.
This enables support for devices where SCL line is not shared between
SFP modules. MUX registry is now initialized depending on needed
pin function.
More over, some SFP pins require special MUX settings, lets initialize
those depending on SFP configuration. This adds TX Disable pin,
which right now is set to low at startup.
Caveats:
- We may still override MUX registry later
- Not sure how to handle invalid bus definitions
- Without SFP is it fine to *not* initialize anything?
- Do to RAM limitation we do inititalize output GPIO to low
This adds an implementation for trapping IGMP packets to the CPU
which will identify IGMPv1/2/3 packets, but handle only v3.
The implementation then inserts/updates/deletes L3 MC entries
in the L3 lookup table. The entries consist of an Ipv4
Destination IP (the IPv4 MC address), a Source IP (0.0.0.0) and
a Portmask. Note that this implementation is not VLAN aware,
as there is no hardware support in the device.
An alternative strategy is to control switching of the L2-MC packets
in which the IPv4-MC packets are transported (dst-MaC is
01:00:5e:xx:yy:zz, with xx:yy:zz corresponding to bits in the Ipv4-MC
address). This will allow to use VLAN-aware packet switching. While
code support is there for table insert/update/deletes, some further
L2 configuration is missing.
There is no support for IPv6 MC, yet.
This adds a command history, both for the CLI as well as for
commands sent by the web-interface. They are written to a ring buffer
in order to work safely with a relatively small amount of RAM
The buffer is used to read the current in-RAM configuration
from the switch by the web-interface. It could also be used
to implement cmd history via cursor up/down in the CLI.
logicog
diijkstra
feelfree69
René van Dorst
logicog