The TODO next to the disabled TCP checksum code asks which bit of the RX tag
carries the result. It is bit 2 of byte 1: the hardware sets it when the L4
checksum is bad.
That answers the question for UDP as well, which was not being checked either
because UIP_CONF_UDP_CHECKSUMS is 0. Both paths now read the flag instead of
running a checksum over the payload on the 8051.
A zero UDP checksum, which is optional in IPv4, is not flagged by the hardware,
so DHCP keeps working and no extra condition is needed.
rx_headers lives in rtlplayground.c, which the host tests do not link, so
test_httpd_tx carries the storage itself the way it already carries uip_buf.
A zeroed descriptor reads as a good checksum, so the existing scenarios are
unaffected.
A new scenario sets the flag on a request and expects it counted as a checksum
error and left unanswered, then sends the same request with the flag clear and
expects it served. Built against uip.c without this change, those first two
checks fail and the two control checks still pass, so the scenario tells the
two versions apart rather than merely exercising the code.
Costs 156 bytes of code on SWTGW218AS and no extra XDATA.
* uip: time out an ESTABLISHED connection whose peer went silent
uIP has no keepalive and no idle timeout for an ESTABLISHED connection, so
a peer that vanishes without FIN or RST holds it open forever. A crashed
client does it, and so does a SYN caught while the switch is still
booting. With UIP_CONF_MAX_CONNECTIONS = 1 that wedges the single slot:
the web UI stops answering, port 80 no longer even SYN-ACKs, and only a
power cycle recovers it. Every other TCP state already has an exit path
(UIP_MAXRTX, UIP_TIME_WAIT_TIMEOUT); idle ESTABLISHED was the one hole.
Close it inside uIP rather than in httpd, so any future TCP service is
covered too. The retransmission timer is unused while nothing is in
flight, so the idle count lives in it: a 1 Hz strobe derived from the
uip_periodic() rate ages it, any arriving segment clears it, and past the
limit the connection is aborted through the same path as UIP_MAXRTX. Two
new options in uipopt.h, default off; this project enables 30 s.
httpd also joins uip_timedout() to its cleanup: it only handled closed
and aborted, so both this timeout and the existing UIP_MAXRTX one would
have left the transfer state stuck on a dead connection.
* uip: keep the tuning values out of the prose
The comment named the timeout and the tick rate, which go stale the
moment either constant is edited. It now says why an idle connection
is aged out and leaves the numbers to the defines under it.
We use the SoC's UUID to generate a fixed MAC for a particular
switch device. The MAC generated uses a Realtek prefix and then
is followed by 3 bytes genertaed from the first 3 bytes of the
UUID xored with the last byte in order to prevent being able
to deduce the UUID from the public MAC.
João Silva
d00f
René van Dorst
bennydiamond
feelfree69
feelfree69
logicog