RTL8373 (non-N) with an RTL8224 quad 2.5G PHY, 2 MB GD25Q16ESIG flash, no PoE.
The wiring is close to the KP-9000-9XHML-X V3.1 (same 8+1 topology, same I2C on
GPIO39/40), but three things differ and were determined on hardware:
- ModAbs is GPIO30 (low with a module inserted, high with an empty cage) and LOS
is GPIO37 (high without light), not GPIO38. GPIO38, the ModAbs pin of the
KP-9000 reference, is tied low on this board, which made the firmware believe a
module was permanently inserted and retry the I2C read forever.
- The reset button is GPIO54, not GPIO48. GPIO48 never changes here, so the
button appeared to do nothing.
- The LED wiring follows the stock port order (pin 3n+m belongs to port n+1,
LED function m), so the mux table is the chip default except that pin 25 --
the SFP LED -- is driven by function 0, the only populated function in SET1.
Per copper port the left LED shows link/activity and the right LED shows
2.5G, matching the front panel labels.
Verified on hardware: all eight 2.5G ports at 10/100/1000/2500 Mbps, 1G and 10G
SFP modules including DDM data, both LED columns, module insert/remove and the
reset button.
